Parts

The Blade Lock holds the Cutter Blade in the Cutterhead and delivers superior holding force compared to Cutter Blades held by screws. Cutter Blade life can be attributed to several things and one of the most dramatic is heat on the Cutter Blade cutting edge. To control the heat, you have to control vibration. The […]

Base Heads are attached to the tools drive shaft and provide a sturdy platform for fastening Membrane and Membrane/Overlay Heads. Base Heads are mounted to the drive shaft of the end prep tool and are for fastening Membrane and Membrane/Overlay Heads. In addition, they feature the ESCO Blade Lock that rigidly holds a Bevel Cutter […]

Attaches the Actuator to the Draw Rod. A small part but a big reason why the ESCO clamping system stays intact. The steel slotted Spring Roll Pin is used to attach the Draw Rod to the Actuator. When the slot in the Actuator’s threaded neck is aligned with the hole in the Draw Rod this […]

Actuators keep the Clamp Ribs evenly spaced and align them with the Mandrel. The Actuator is threaded onto and then pinned to the Draw Rod. It captures one end of the Clamp Ribs in a slot and when the Draw Rod Wench is activated it permits them to evenly expand and contract on the tapered […]

ESCO Membrane and Overlay Heads are patented and feature a Golf T shaped cutting insert that requires no screws to hold it securely in place. ESCO Membrane Heads fit over the tube O.D. and remove the membrane from between boiler waterwall tubes while not degregating the tube O.D. Membrane/Overlay Heads also remove membrane from between […]