Parts

Mandrels are gun drilled, heat treated and the threads are precisionally ground for extreme duty and maximum life. Three Mandrels are offered: the 1.250in being the most common and the 1in and .750in Mandrels for small tubes that require the stability and power the Wart offers. WART CLAMP RIB SELECTOR RIB SETS AND CORRESPONDING SPARES […]

Golf T shaped inserts are easily attached to the Membrane or Membrane/Overlay Heads without screws that can break. The Patented Golf T shaped insert has a precision ground cutting edge that gets under the surface of the material being removed and transfers heat away from the milling action which allows it to run relatively cool […]

The draw rod actuates the clamps on the mandrel. We make our Draw Rods out of heat treated vessel rod because we don’t want them to break. This simple part can cause big headaches if it is not made of the best material. Our Draw Rods are! The G Series Clamp Ribs use H-247 Draw […]

All MILLHOG® end prep tool Cutterheads feature the EscoLock Blade Lock system that hold the Cutter Blades rigidly in place, reduce vibration and heat on the cutting edge resulting in superior Cutter Blade life without cutting oils. Cutterheads can hold up to three different Cutter Blades at one time to simultaneously bevel, face and bore. Cutterheads […]

MILLHOG® Cutter Blades produce a thick chip without cutting fluids on high alloy pipe and tube. MILLHOG® Cutter Blades are rigidly held in the Cutterhead with the ESCO Blade Lock Wedge and the right and left hand double threaded Blade Lock Screw. This combination takes full advantage of the Blade Locks angled surface that makes full contact […]